You may have noticed that sometimes the gear shifter vibrates.
Shifter vibration is not a bad thing because it is something that happens by design - a little flex is a good thing.
However, if you feel that vibration is on the higher side then here is your solution-
- Get a large size zip tie
- Tie the zip tie around gear cable near the firewall
- Tighten by 0.5-1.0 cm only, do NOT over tighten. Over tightening may cause premature wear in gear cable. Gear cables should not touch each other.
Advantage: Better gear shift quality and less vibration.
My Brio-
03-02-2016, 11:17 PM (This post was last modified: 03-05-2016, 04:24 PM by MICROHIT.)